Construct the jumper tool as shown in the above photo using the appropriate BMW pin for the 15 or 20 pin connector. I epoxied the ridge of the pin to the banana plug. I also placed a drop of epoxy at the other end of the banana plug. You can easily make your own tool. Reset Instructions: For cars with the 15 pin diagnostic connector With the ignition switch at position two and the engine not running, grounding pin seven 7 of the diagnostic connector for approximately three 3 seconds will reset the oil service lights.
Grounding pin seven 7 for approximately twelve 12 seconds will do an inspection service reset. Connect the clip end of the jumper tool to a good ground in the area of the diagnostic connector. Connect the pin end of the jumper tool to pin seven 7 of the diagnostic connector. Enter the car and turn the ignition switch to position two 2.
This way you can watch the lights reset. Turn off the ignition switch when you see the lights reset after the appropriate time. This time as mentioned above depends on whether you are doing an oil or inspection service reset. Remove the jumper and replace the diagnostic connector cap. For cars with the 20 pin data link connector On the newer cars you also have to place the ignition switch in position two.
You provide a short and then remove it after a specified time. The reset occurs on removal. On the older cars the reset occurred after the specified time. That's the difference between the older diagnostic connector and the newer data link connector.
I purchased a Peake reset tool to find out what these times were. They say to provide the short for 7 flashes for an oil service reset and 23 flashes for an inspection reset. Turn the ignition switch to position two 2. Or any error which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders when by yourself. This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly.
If you would have anything to add, for us every opinion counts. Click hear to see full procedure how do you reset the oil light indicator.
How to reset the maintenance light and how do you reset service light for all BMW cars. When I changed the seats the airbag light went on. It will reset! Your email address will not be published.
0コメント